Skip to main content

Can You Check The Weight of CO2 Cylinder Through Radio Isotope Gun Weather Cylinder is Empty or Not?


  • Weight cannot be checked with help of radio isotope gun
  • Isotope gun gives percentage full of the bottle capacity or how full the bottle is.
  • It is understood that if bottles is 90% full or 95% full then there is no need of doing any weight checks.
  • Isotopes checks level of CO2 inside bottle
  • For checking you have separate tools(beam scale assembly) for ship staff to check or shore people will come and do it. 
     

  • Loosen out the clamp block securing the cylinder.
  • Arrange beam scale in position hooking the cylinder with york of beam scale.
  • One time, pull down the beam scale and hook up the cylinder completely from the seat and put it to original position. Then the cylinder will be free from any surface contacts.
  • Now slowly pull down the beam scale to 90 degree against hook and the bottle will be lifted from the seat just a few mm and read the scale.
NOTE: Recharge the cylinder if there is 10% reduction in weight.
             +/- 5 degree of beam angle is allowed for measuring the                   cylinder.


Comments

Popular posts from this blog

Difference Between A, B & C-Class Divisions?

IMO Symbol A Class Division  IMO Symbol B Class Division  SOLAS has tables for structural fire protection requirement of bulkheads and decks. The requirements depend on the spaces in question and are different for passenger ships and cargo ships. The Administration has required a test of a prototype bulkhead or deck in accordance with the Fire Test Procedures Code to ensure that it meets the above requirements for integrity and temperature rise. Types of Divisions: "A" Class "B" Class "C" Class "A" Class: "A" class divisions are those divisions formed by bulkheads and decks which comply with the following criteria: They are constructed of steel or equivalent material They are suitably stiffened They are constructed as to be capable of preventing the passage of smoke and flame to the end of the one-hour standard fire test. they are insulated with approved non-combustible materials such that the average tempera

Why do we blow through engine before starting ?

The engine is blown through on air before starting it : a) To Blow out through indicator cock any residual exhaust gas or     other products of combustion trapped inside the cylinder after     shutting the engine. b) To check if any jacket cooling water from cylinder head or     turbocharger or any other source, has leaked while the engine          was shut and collected on top of piston. If while blowing                  through, water comes out of indicator cock or relief valve, we          need to investigate and rectify the fault before starting the                engine. It is imperative that the engine is blown through before        starting. There have been cases where the generator engine has        been started from control room without bothering to blow     through first, and water collected on top of piston has resulted in      a bent connecting rod and broken piston.( Reason – water can          not be compressed )

Load Line & Why it is Important

Merchant ships have a marking on their hull know as the Plimsoll line or the Plimsoll mark, which indicates the limit until which ships can be loaded with enough cargo, internationally, the Plimsoll line on a ship is officially referred to as the international load line. Every type of ship has a different level of floating and the Plimsoll line on a ship generally varies from one vessel to another.  All vessels of 24 meters and more are required to have this Load line marking at the centre position of the length of summer load water line. There are two types of Load line markings:- Standard Load Line marking – This is applicable to all types of vessels. Timber Load Line Markings – This is applicable to vessels carrying timber cargo. These marks shall be punched on the surface of the hull making it visible even if the ship side paint fades out. The marks shall again be painted with white or yellow colour on a dark background/black on a light background.  The comp